LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P1211 Through P2A03 >> DTC P2A00, P2A03 A/F Sensor 1 >> DTC Confirmation Procedure >> With GST
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Disconnect mass air flow sensor harness connector.
  6. Start engine and let it idle for at least 5 seconds.
  7. Stop engine and reconnect mass air flow sensor harness connector.
  8. Select Service $03 with GST and make sure that DTC P0102 is detected.
  9. Select Service $04 with GST and erase the DTC P0102.
  10. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for 1 minute under no load.
  11. Let engine idle for 1 minute.
    Fig 1: Identifying Mass Air Flow Sensor Harness Connector
    G04905244Courtesy of NISSAN MOTOR CO., U.S.A.
  12. Keep engine speed between 2, 500 and 3, 000 rpm for 20 minutes.
  13. Select Service $07 with GST.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About LEMON Manuals