LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS U1000 Through P0153 >> DTC P0133, P0153 A/F Sensor 1 >> DTC Confirmation Procedure >> With GST
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Select Service $01 with GST.
  3. Calculate the total value of "Short term fuel trim" and "Long term fuel trim" indications.

    Make sure that the total percentage should be within ±15%.

    If OK, go to the following step.

    If NG, check the following.

    • Intake air leaks
    • Exhaust gas leaks
    • Incorrect fuel pressure
    • Lack of fuel
    • Fuel injectors
    • Incorrect PCV hose connection
    • PCV valve
    • Mass air flow sensor
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Turn ignition switch ON.
  6. Turn ignition switch OFF and wait at least 10 seconds.
  7. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1minute under no load.
  8. Let engine idle for 1 minute.
  9. Increase the engine speed up to 4, 000 to 5, 000 rpm and keep it for 10 seconds.
  10. Fully release accelerator pedal and then let engine idle for about 1 minute.
  11. Select Service $07 with GST.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".