With Consult-III
- Turn ignition switch ON wait at least 10 seconds.
- Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If 1st trip DTC is not detected, go to following step.
- Select "DATA MONITOR" mode with CONSULT-III.
- Check "COOLAN TEMP/S" value.
If the "COOLAN TEMP/S" is less than 60°C (140°F), the result will be OK.
If the "COOLAN TEMP/S" is above 60°C (140°F), go to the following step.
- Cool engine down until "COOLAN TEMP/S" signal is less than 60°C (140°F).
- Wait at least 10 seconds.
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".