CVT Models

CHECK PNP SWITCH POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect PNP switch harness connector.
3. Turn ignition switch ON.
4. Check voltage between PNP switch terminal 7 and ground with CONSULT-III or tester.
  Voltage: Battery voltage
OK or NG

OK: GO TO 3.

NG: GO TO 2.

Fig 1: Checking Voltage Between PNP Switch Terminal 7 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E3, F2
- 10A fuse
- Harness for open or short between PNP switch and fuse
: Repair open circuit or short to ground or short to power in harness or connectors.
CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check harness continuity between PNP switch terminal 6 and ECM terminal 102.
  Refer to WIRING DIAGRAM .
  
  Continuity should exist.
4. Also check harness for short to ground and short to power.
OK or NG

OK: GO TO 5.

NG: GO TO 4.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors F2, E3
- Harness for open or short between PNP switch and ECM
: Repair open circuit or short to ground or short to power in harness or connectors.
CHECK PNP SWITCH
Refer to "DTC P0705 PARK/NEUTRAL POSITION SWITCH ".

OK or NG

OK: GO TO 6.

NG: Replace PNP switch.
CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

: INSPECTION END