Preliminary Check

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK WARNING INDICATOR ILLUMINATION
1. Turn ignition switch ON.
2. Make sure warning indicators (such as malfunction indicator lamp and oil pressure warning indicator) illuminate.
Do warning indicators illuminate?

YES: GO TO 2.

NO: Check ignition power supply system of combination meter. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".
CHECK OPERATION OF SELF-DIAGNOSIS MODE (COMBINATION METER)
Perform self-diagnosis mode of combination meter. Refer to "SELF-DIAGNOSIS MODE OF COMBINATION METER ".

Does self-diagnosis mode operate normally?

YES: GO TO 3.

NO: Check combination meter power supply and ground circuit. Refer to "POWER SUPPLY AND GROUND CIRCUIT INSPECTION ".
CHECK ODOMETER OPERATION
Check segment display status of odometer.

Fig 1: Checking Odometer Operation

Is the display normal?

YES: GO TO 4.

NO: Replace the combination meter. Refer to "COMBINATION METER ".
CHECK COMBINATION METER CIRCUIT
Check operation of each meter/gauge in self-diagnosis mode.

OK or NG

OK: GO TO 5.

NG: Replace the combination meter. Refer to "COMBINATION METER ".
CHECK SELF-DIAGNOSTIC RESULTS OF METER
Select "METER" on CONSULT-II and perform self-diagnosis of meter.

Self-diagnostic results content

CAN COMM CIRC [U1000]: Refer to "DTC [U1000] CAN COMMUNICATION CIRCUIT ".

VEHICLE SPEED CIRC [B2205]: Refer to "DTC [B2205] VEHICLE SPEED CIRCUIT ".