LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension System >> Stabilizer Bar >> Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation: Removal

  1. Separate intermediate shaft from steering gear pinion shaft. Refer to "COMPONENTS ".
  2. Remove front tires using power tool.
  3. Remove the nut on the lower side of stabilizer connecting rod using power tool, and then remove stabilizer connecting rod from stabilizer bar.
  4. If necessary remove stabilize connecting rod upper nut using power tool. Separate stabilizer connecting rod and strut.
  5. Loosen steering outer socket (1) nut.
  6. Remove steering outer socket (1) from steering knuckle (2) so as not to damage ball joint boot (3) using Tool.

    Tool number : HT72520000 (J-25730-A) 

    CAUTION: Temporarily tighten the nut to prevent damage to threads and to prevent the Tool from suddenly coming off.
    Fig 1: Identifying Steering Outer Socket Mounting Nut And Steering Knuckle
    G04927149Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove rear torque rod. Refer to "COMPONENTS ".
  8. Set Tool under the front suspension member, then remove the bolts from the front suspension member using power tool.

    Tool number : KV101J0010 (J-47242) 

  9. Remove the bolts of member stay using power tool, and then remove member stay.
  10. Gradually lower front suspension member in order to remove stabilizer bolts.
    Fig 2: Setting Jack Under Front Suspension Member
    G04927238Courtesy of NISSAN MOTOR CO., U.S.A.
  11. Remove the stabilizer clamp bolts, then remove stabilizer clamps and stabilizer bushing.
  12. Remove stabilizer bar.
    Fig 3: Locating Stabilizer Clamp Bolts
    G04927239Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals