Removal and Installation: Installation

CAUTION:

Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
After installing key interlock cable to control device assembly, make sure that casing cap and bracket are firmly secured in their positions.

Place the selector lever in the "P" position.
Turn ignition switch to "ACC" or "ON" position.
Set the key interlock cable (1) to the key cylinder (2).
Install the lock plate (A) to the holder (B).
Turn ignition switch to "LOCK" position.

Fig 1: Identifying Key Interlock Cable From Key Cylinder
Courtesy of NISSAN MOTOR CO., U.S.A.
Temporarily install the adjust holder (A) to the key interlock rod (B).
Install the casing cap (C) to the cable bracket (D) on the control device assembly.
CAUTION:
- Do not bend or twist key interlock cable excessively when installing.
- After installing key interlock cable to cable bracket (D) on control device assembly, make sure casing caps (C) is firmly secured in cable bracket (D) on control device assembly.
  
  Fig 2: Locating Casing Cap To Cable Bracket On Control Device Assembly
  Courtesy of NISSAN MOTOR CO., U.S.A.
- If casing cap (C) is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.
Install shift knob in "P" position.
Pull the adjust holder (C) all the way to the left on the key interlock rod (B). Move the slider (A) toward the key interlock rod (B) and lock it.
CAUTION:
- Do not press tabs when holding slider (A).
- Do not apply any force to key interlock rod (B) when sliding slider (A).
  
  Fig 3: Identifying Adjust Holder And Key Interlock Rod
  Courtesy of NISSAN MOTOR CO., U.S.A.
Secure the key interlock cable with the clip.
Installation of the remaining components is in the reverse order of removal.
Check shift lock system. Refer to "DESCRIPTION ".