April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "SPECIAL REPAIR REQUIREMENT ".
Turn ignition switch ON.
Set selector lever to D (CVT) or 1st (M/T) position.
Check the voltage between ECM harness connector and ground.

TERMINAL VOLTAGE REFERENCE CHART

ECM		Ground	Condition		Voltage
Connector	Terminal	Ground	Condition		Voltage
F8	33 (TP sensor 1 signal)	Ground	Accelerator pedal	Fully released	More than 0.36 V
	33 (TP sensor 1 signal)			Fully depressed	Less than 4.75 V
	34 (TP sensor 2 signal)			Fully released	Less than 4.75 V
	34 (TP sensor 2 signal)			Fully depressed	More than 0.36 V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace electric throttle control actuator.
2. Perform "SPECIAL REPAIR REQUIREMENT ".
INSPECTION END