ID Registration Without Transmitter Activation Tool
- With the ignition switch in OFF position, connect scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
- Display "WORK SUPPORT" screen, and select "ID REGIST".
- Set the tire pressure of each wheel to the specification shown in the Sensor ID Registration Tire Pressure Specifications table. Then drive the vehicle at 25 mph (40 km/h) or above for more than 3 minutes.NOTE: On 2008 models, if ID registration is unable to be completed, a buzzer sounds.Sensor ID Registration Tire Pressure Specifications
Tire Position Tire Pressure - psi (kPa) Front Left 35 (240) Front Right 31 (220) Rear Right 29 (200) Rear Left 26 (180) - After completing all ID registrations, press "END" to complete the procedure.
- Inflate all tires to specification.