Diagnosis Procedure
- CHECK FUEL INJECTOR POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect fuel injector harness connector.
- Turn ignition switch ON.
- Check the voltage between fuel injector harness connector and ground.VOLTAGE SPECIFICATION
Fuel injector Ground Voltage Cylinder Connector Terminal 1 F17 1 Ground Battery voltage 2 F18 1 3 F19 1 4 F20 1 5 F21 1 6 F22 1
Is the inspection result normal?
YES: GO TO 3.
NO: GO TO 2.
- DETECT MALFUNCTIONING PART
Check the following.
- 10 A fuse (No. 35)
- IPDM E/R harness connector E10
- Harness for open or short between fuel injector and fuse
: Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK FUEL INJECTOR OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between fuel injector harness connector and ECM harness connector.CONTINUITY CHART
Fuel injector ECM Continuity Cylinder Connector Terminal Connector Terminal 1 F17 2 F14 32 Existed 2 F18 2 31 3 F19 2 30 4 F20 2 29 5 F21 2 3 6 F22 2 1 - Also check harness for short to ground and short to power.
Is the inspection result normal?
YES: GO TO 4.
NO: Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK FUEL INJECTOR
Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: GO TO 5.
NO: Replace malfunctioning fuel injector.
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
Is the inspection result normal?
YES: Replace IPDM E/R.
NO: INSPECTION END