Without Consult-III
- To locate the EVAP leakage, install EVAP service port adapter (commercial service tool) and pressure pump to EVAP service port.
- Apply battery voltage between the terminals of EVAP canister vent control valve to make a closed EVAP system.
- To locate the leakage, deliver positive pressure to the EVAP system until pressure gauge points reach 1.38 to 2.76 kPa (0.014 to 0.028 kg/cm2
, 0.2 to 0.4 psi).
- Remove EVAP service port adapter (commercial service tool) and hose with pressure pump.
Courtesy of NISSAN MOTOR CO., U.S.A.
- Locate the leakage using a leakage detector (commercial service tool). Refer to
"SYSTEM DIAGRAM
".
Courtesy of NISSAN MOTOR CO., U.S.A.