DTC Confirmation Procedure: Notes
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
- P0400 will not be displayed at "SELF-DIAG RESULTS" mode with CONSULT-III even though DTC work support test result is NG.
TESTING CONDITION:
- Before performing the following procedure, confirm battery voltage is more than 10 V at idle, then stop engine immediately.
- For best results, perform the test at a temperature of 5°C (41°F) or higher.