DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.
- Start engine and warm it up to normal operating temperature.
- Rev engine from idle to 2, 000 RPM for 10 times.
- Check DTC.
- If DTC is detected, go to , "DIAGNOSIS PROCEDURE ".