Inspection Procedure

1. Turn ignition switch OFF.
2. Connect GST to data link connector (2), which is located under LH dash panel near the hood opener handle.
   • Brake pedal (1)
3. Turn ignition switch ON.
   Fig 1: Identifying Data Link Connector And Brake Pedal

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Enter the program according to instruction on the screen or in the operation manual.

   (* : Regarding GST screens in this article, sample screens are shown.)

   Fig 2: Generic Scan Tool Screen Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
5. Perform each diagnostic service according to each service procedure.

For further information  , see the GST Operation Manual of the tool maker. 

Fig 3: Generic Scan Tool Display - READINESS TESTS

Courtesy of NISSAN MOTOR CO., U.S.A.