April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Power Window LH Circuit Inspection

CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL

Turn ignition switch ON.
Check voltage between main power window and door lock/unlock switch connector and ground.

VOLTAGE SPECIFICATION

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D5	16	Ground	UP	0
	16		DOWN	Battery voltage
	12		UP	Battery voltage
	12		DOWN	0

Fig 1: Checking Voltage Between Main Power Window And Door Lock/Unlock Switch Connector And Ground

G05922833

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Replace main power window and door lock/unlock switch. Refer to "REMOVAL AND INSTALLATION ".

CHECK POWER WINDOW MOTOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect main power window and door lock/unlock switch and front power window motor LH.
3. Check continuity between main power window and door lock/unlock switch connector D5 (A) terminals 6, 7 and front power window motor LH connector D8 (B) terminals 1, 3.
  16 - 3 : Continuity should exist.
  
  12 - 1 : Continuity should exist.
4. Check continuity between main power window and door lock/unlock switch connector (A) terminals 6, 7 and ground.
  
  Fig 2: Checking Continuity Between Main Power Window And Door Lock/Unlock Switch Connector Terminals And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  16 - Ground : Continuity should not exist.
  
  12 - Ground : Continuity should not exist.
OK or NG

OK: Replace front power window motor LH. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace harness.