LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - Component Testing (MR20DE-CALIFORNIA)) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stop Lamp Switch

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04925545Courtesy of NISSAN MOTOR CO., U.S.A.
    CONTINUITY SPECIFICATION

    Condition Continuity
    Brake pedal: Fully released. Should not exist.
    Brake pedal: Slightly depressed. Should exist.

    If NG, adjust stop lamp switch installation, refer to BRAKE PEDAL , and perform step  3 again.

scientia non olet · About LEMON Manuals