Consult-III ECM Reprogramming Procedure (NTB09-029)

WARNING: This page is about the Sentra Base, Automatic CVT, which is a different variant/trim than selected.

Publication date: 2009-04-21
Reference number: NTB09-029

CONSULT-III ECM REPROGRAMMING PROCEDURE

TECHNICAL SERVICE BULLETIN

Reference Number(s): NTB09-029, Date of Issue: April 21, 2009

NISSAN:	All CONSULT-III (C-III) compatible Nissan vehicles
CLASSIFICATION:	EC09-007
APPLIED VEHICLES:	All CONSULT-III (C-III) compatible Nissan vehicles

A complete step-by-step General Procedure for C-III ECM Reprogramming is now available by hyperlink.

This General Procedure is also available via hyperlink from specific C-III symptom-based Technical Service Bulletins in ASIST.

CAUTION: BEFORE STARTING REPROGRAMMING

Connect a battery charger to the vehicle battery.
If the 12V battery voltage drops during reprogramming, the ECM may be damaged.
Be sure to turn OFF all vehicle electrical loads.
If a vehicle electrical load remains ON, the ECM may be damaged.
For ECM reprogramming, the C-III MUST be connected to the VI using the USB cable.
Be sure to connect the AC Adapter.
If the C-III battery voltage drops during reprogramming, the process will be interrupted and the ECM will be damaged.