DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III

Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
Start engine and maintain the following conditions for at least 5 consecutive seconds.
VEHICLE SPEED SE: 10 km/h (6 MPH) or more

ACC PEDAL OPEN: More than 1.0/8

RANGE: "D" position

ENG SPEED: 450 RPM or more

Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
If DTC is detected, go to "DIAGNOSIS PROCEDURE ".