Component Function Check

START
Check that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5, 000 km (3, 107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30°C (68 - 86°F)
- Engine COOLANT temperature: 75 - 95°C (167 - 203°F)
- Transmission: Warmed-up
  - After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" in "DATA MONITOR" mode of "CVT" system indicates less than 0.9 V.
- Electrical load: Not applied
  - Rear window defogger switch, air conditioner switch lighting switch are OFF. Steering wheel is straight ahead.
- Engine speed: Idle
  GO TO 2.
PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE: Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Perform " "BASIC INSPECTION : SPECIAL REPAIR REQUIREMENT "".
2. Select "B/FUEL SCHDL", "A/F ALPHA-B1", "A/F ALPHA-B2" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
3. Check that monitor items are within the SP value.
  Is the measurement value within the SP value?
  
  YES >> INSPECTION END
  
  NO >> Go to "DIAGNOSIS PROCEDURE ".