Diagnosis Procedure
CAUTION:
ABS does not operate when speed is 10 km/h (6 MPH) or lower.
- CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp turns OFF after ignition switch is turned on or when driving.
Is the inspection result normal?
YES >> GO TO 2
NO >> Perform self-diagnosis. Refer to "CONSULT-III FUNCTION (ABS) ".
- CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
- Wheel sensor installation for damage.
- Sensor rotor installation for damage.
- Wheel sensor connector connection.
- Wheel sensor harness inspection.
Is the inspection result normal?
YES >> GO TO 3
NO >>
- Replace wheel sensor or sensor rotor. Refer to "REMOVAL AND INSTALLATION " or "REMOVAL AND INSTALLATION ".
- Repair harness.
- CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving.
Is the inspection result normal?
YES >> Inspection End.
NO >> Perform self-diagnosis. Refer to "CONSULT-III FUNCTION (ABS) ".