Component Inspection

With CONSULT 

1. Turn ignition switch OFF.
2. Reconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
4. Turn ignition switch ON.
5. Select "ENGINE MOUNTING" in "ACTIVE TEST" mode with CONSULT.
6. Check air passage continuity and operation delay time under the following conditions.
   TERMINAL CONTINUITY REFERENCE CHART
   
   

   Condition (ENGINE MOUNTING)	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
   TRVL	Existed	Not existed
   IDLE	Not existed	Existed

   Fig 1: Identifying VIAS Control Solenoid Valve 1

   Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT 

1. Turn ignition switch OFF.
2. Disconnect electronic controlled engine mount control solenoid valve harness connector.
3. Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
4. Check air passage continuity and operation delay time under the following conditions.
   TERMINAL CONTINUITY REFERENCE CHART
   
   

   Condition	Air passage continuity between (A) and (B)	Air passage continuity between (A) and (C)
   12 V direct current supply between terminals 1 and 2	Existed	Not existed
   No supply	Not existed	Existed

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Replace electronic controlled engine mount control solenoid valve. Refer to "EXPLODED VIEW ".

   Fig 2: Checking Air Passage Continuity

   Courtesy of NISSAN MOTOR CO., U.S.A.