Active Test
CAUTION:
- Do not perform active test while driving.
- Make sure to completely bleed air from the brake system.
- The ABS and brake warning lamps turn on during the active test.
Solenoid Valve Operation Chart
SOLENOID VALVE OPERATION CHART
| TEST ITEM | CONDITION | JUDGEMENT | ||||
|---|---|---|---|---|---|---|
| FR RH SOL FR LH SOL RR RH SOL RR LH SOL |
Ignition switch is turned ON. | Brake fluid pressure control operation | ||||
| IN SOL | OUT SOL | |||||
| UP (Increase): | OFF | OFF | ||||
| KEEP (Hold): | ON | OFF | ||||
| DOWN (Decrease): | ON | ON(1) | ||||
|
||||||
NOTE:
- If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
- "TEST IS STOPPED" is displayed approximately 10 seconds after operation starts.
- After "TEST IS STOPPED" is displayed, to perform test again, reselect item to be tested.
ABS Motor
Touch "ON" and "OFF" on the screen. Check that ABS motor relay operates as shown in table below.
OPERATION CHART
| Operation | ON | OFF |
|---|---|---|
| ABS actuator relay | ON | ON |
| ABS motor relay | ON | OFF |
NOTE:
- If active test is performed with brake pedal depressed, pedal stroke may change. This is normal.
- "TEST IS STOPPED" is displayed approximately 10 seconds after operation starts.