LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2011 >> Sentra SE-R >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> ID Registration With Transmitter Activation Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ID Registration With Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6. With the Transmitter Activation Tool (J-45295) pushed against the front left transmitter tire air valve, press the button for 5 seconds. See Fig 1.
  7. Register the IDs in the following order: Left Front, Right Front, Right Rear, Left Rear. When ID registration of each wheel has been completed, a buzzer sounds (or a chime, in 2004 models) as indicated in the table, the hazard warning lights or turn signal indicators flash twice, and the indictor light on the Activation Tool goes from red to green.
    NOTE: Be sure to register the IDs in the specified order, or the self-diagnostic results display will not function properly.
  8. After completing all ID registrations, press "END" to complete the procedure.
    9. Fig 1: Identifying Transmitter Activation Tool (J-45295) - Typical
    G00225482Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals