ECM: Special Repair Requirement

PERFORM ECM RECOMMUNICATING FUNCTION
1. Install ECM.
2. Contact backside of the registered Intelligent Key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
  *: To perform this step, use the key that is used before performing ECM replacement.
3. Maintain ignition switch in the ON position for at least 5 seconds.
4. Turn ignition switch OFF.
5. Start engine.
  >> GO TO 2.
PERFORM ADDITIONAL SERVICE PROCEDURE WHEN REPLACING ECM
performing the following procedure.
- HR18DE (Except for California): "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT "
- HR18DE (For California): "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT: SPECIAL REPAIR REQUIREMENT "
  >> END