Push-Button Ignition Switch Operation Procedure

The power supply position changing operation can be performed with the following operation.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when it is inserted in to the key slot, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions,
- Brake pedal operating condition
- CVT selector lever position
- Vehicle speed
Unless each start condition is fulfilled, the engine will not respond regardless of how many times the engine switch is pressed. At that time, illumination repeats the position in the order of LOCK→ACC→ON→OFF.

Power supply position

Engine start/stop condition

Push-button ignition switch operation frequency

Brake pedal

CVT selector lever position

LOCK → ACC

Not depressed

Any position

LOCK → ACC → ON

Not depressed

Any position

LOCK → ACC → ON → OFF

Not depressed

Any position

LOCK → START
ACC → START
ON → START (Engine start)

Depressed

P or N position (⁽¹⁾)

1
[If the switch is pressed once, the engine starts from any power supply position (LOCK, ACC, and ON)]

Engine is running → OFF (Engine stop)

Any position

Engine is running → ACC (Engine stop)

Any position other than P (⁽²⁾)

Engine stall return operation while driving

N position

⁽¹⁾	When the CVT selector lever position is N position, the engine start condition is different according to the vehicle speed.

At vehicle speed of 4 km/h (2 MPH) or less, the engine can start only when the brake pedal is depressed.
At vehicle speed of 4 km/h (2 MPH) or more, the engine can start even if the brake pedal is not depressed. (It is the same as "Engine stall return operation while driving".)

⁽²⁾	When the CVT selector lever position is in any position other than P position and when the vehicle speed is 5 km/h or more, the engine stop condition is different.

Press and hold the push-button ignition switch for 2 seconds or more. (When the push-button ignition switch is pressed for too short a time, the operation may be invalid, so properly press and hold to prevent the incorrect operation.)
Press the push-button ignition switch 3 times or more within 1.5 seconds. (Emergency stop operation)