RELAY CONTROL SYSTEM: System Description
IPDM E/R activates the internal control circuit to perform the relay ON-OFF control according to the input signals from various sensors and the request signals received from control units via CAN communication.
CAUTION:
To prevent damage to the parts, IPDM E/R integrated relays cannot be removed.
| Control relay | Input/output | Transmit unit | Control part | Refer to | ||
|---|---|---|---|---|---|---|
| Headlamp low relay | Low beam request signal | BCM (CAN) | Headlamp (LO) | |||
| Headlamp high relay | High beam request signal | BCM (CAN) | Headlamp (HI) | |||
| Front fog lamp relay | Front fog light request signal | BCM (CAN) | Front fog lamp |
|
||
| Tail lamp relay | Position light request signal | BCM (CAN) |
|
|||
| Illumination | ILLUMINATION CONTROL SYSTEM: SYSTEM DESCRIPTION | |||||
|
Front wiper request signal | BCM (CAN) | Front wiper motor | SYSTEM | ||
| Front wiper stop position signal | Front wiper motor | |||||
| Horn relay |
|
BCM (CAN) |
|
VEHICLE SECURITY SYSTEM: SYSTEM DIAGRAM | ||
|
Starter control relay signal | BCM (CAN) | Starter motor | SYSTEM DESCRIPTION | ||
| Starter relay control signal | TCM | |||||
| Starter motor relay cut off signal | ECM (CAN) | STARTER MOTOR DRIVE CONTROL: SYSTEM DIAGRAM | ||||
| A/C relay | A/C compressor request signal | ECM (CAN) | A/C compressor (magnet clutch) |
|
||
|
Cooling fan speed request signal | ECM (CAN) |
|
COAST OPERATION | ||
| Ignition relay | Ignition switch ON signal | BCM (CAN) | Each control unit, sensor, actuator and relay (ignition power supply) | B2098 IGNITION RELAY ON STUCK | ||
| Vehicle speed signal | Combination meter (CAN) | |||||
| Push-button ignition switch signal | Push-button ignition switch | |||||
| Daytime running light relay | Daytime running light request signal | BCM (CAN) | Headlamp (HI) |
|
||
|
||||||