CVT Shift Selector (Park Position Switch) Check

1. Turn ignition switch OFF.
2. Check for continuity between Intelligent Key unit harness connector M42 terminal 10 and ground.

   Connector	Terminals		Condition	Continuity
   	(+)	(-)
   M42	10	Ground	Selector lever is in "P" position	Yes
   			Other than above	No

   Fig 1: Checking CVT Shift Selector (Park Position Switch) Input Signal

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: Replace Intelligent Key unit. Refer to , "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

   NG: GO TO 2.

1. Disconnect CVT shift selector (park position switch) connector.
2. Check for continuity between CVT shift selector (park position switch) harness connector M38 terminal 2 and ground.

   2 - Ground: Continuity should exist  .

   Fig 2: Checking CVT Shift Selector (Park Position Switch) Ground Circuit

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: GO TO 3.

   NG: Repair or replace harness.

Check continuity between CVT shift selector (park position switch) terminals 2 and 5.

Fig 3: Checking CVT Shift Selector (Park Position Switch)

Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: Repair or replace harness.

NG: Replace CVT shift selector (park position switch).