Sunroof Switch System Inspection

1. Turn ignition switch ON.
2. Check voltage between sunroof motor assembly connector and ground.

   Connector	Terminal		Condition	Voltage (Approx.)
   	(+)	(-)
   R26	1	Ground	Sunroof switch is operated to UP/CLOSE	0
   			Other than above	Battery voltage
   	5		Sunroof switch is operated to DOWN/OPEN	0
   			Other than above	Battery voltage

   Fig 1: Checking Sunroof Switch Input Signal

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: Sunroof switch input signal circuits are OK.

   NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect sunroof motor assembly and sunroof switch.
3. Check continuity between sunroof motor assembly connector R26 terminals 1, 5 and sunroof switch connector R27 terminals 1, 3.

   1 - 3: Continuity should exist  .

   5 - 1: Continuity should exist  .

4. Check continuity between sunroof motor assembly connector R26 terminals 1, 5 and ground.

   1 - Ground: Continuity should not exist  .

   5 - Ground: Continuity should not exist  .

   Fig 2: Checking Sunroof Switch Circuit

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: GO TO 3.

   NG: Repair or replace harness.

Check continuity between sunroof switch connector R27 terminal 2 and ground.

2 - Ground: Continuity should exist  .

Fig 3: Checking Sunroof Switch Ground Circuit

Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness.

Check continuity between sunroof switch terminals 1, 3 and 2.

Fig 4: Checking Sunroof Switch

Courtesy of NISSAN NORTH AMERICA, INC.

OK or NG 

OK: Replace sunroof motor assembly. Refer to , "REMOVAL AND INSTALLATION ".

NG: Replace sunroof switch.