DTC Confirmation Procedure

TESTING CONDITION: 

• Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface  .
• Open engine hood before conducting the following procedure  .

WITH CONSULT

1. Tighten fuel filler cap securely until reteaching sound is heard.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
4. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
5. Check that the following conditions are met.

   COOLAN TEMP/S: 0 - 100°C (32 - 212°F) 

   INT/A TEMP SE: 0 - 60°C (32 - 140°F) 

6. Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT.

   Follow the instruction displayed.

   NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT screen, go to "BASIC INSPECTION ".
7. Check that "OK" is displayed.

If "NG" is displayed, select "SELF-DIAG RESULTS" mode with CONSULT and check that "EVAP GROSS LEAK [P0455]" is displayed. If it is displayed, refer to "DIAGNOSIS PROCEDURE ".

If P0442 is displayed, perform Diagnostic Procedure for DTC P0442, "DIAGNOSIS PROCEDURE ".

WITH GST

1. Start engine.
2. Drive vehicle according to Driving Pattern, "EMISSION-RELATED DIAGNOSTIC INFORMATION ".
3. Stop vehicle.
4. Turn ignition switch OFF, wait at least 10 seconds and then turn ignition switch ON.
5. Select Service $07 with GST.

• If P0441 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".
• If P0442 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".
• If P0455 is displayed on the screen, go to "DIAGNOSIS PROCEDURE ".