DTC Confirmation Procedure
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT.
- Start engine.
- Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
- Check 1st trip DTC.
- If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
WITH GST
Follow the procedure "WITH CONSULT" above.