Overall Function Check

Use this procedure to check the overall function of the heated oxygen sensor 2 circuit. During this check, a 1st trip DTC might not be confirmed.

WITH GST

1. Start engine and warm it up to the normal operating temperature.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Start engine and keep the engine between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
4. Let engine idle for 1 minute.
5. Set voltmeter probes between ECM terminal 33 [HO2S2 (b1) signal] or 34 [HO2S2 (B2) signal] and ground.
6. Check the voltage when revving up to 4, 000 rpm under no load at least 10 times.

   (Depress and release accelerator pedal as soon as possible.)

   A change of voltage should be more than 0.8 V for 1 second during this procedure  .

   If the voltage can be confirmed in step   6 , step 7 is not necessary  .

7. Keep vehicle at idling for 10 minutes, then check the voltage. Or check the voltage when coasting from 80 km/h (50 MPH) in D position (CVT) or 3rd gear position (M/T).

   A change of voltage should be more than 0.8 V for 1 second during this procedure  .

   Fig 1: Checking Voltage Between ECM Terminals 33 And 34

   Courtesy of NISSAN NORTH AMERICA, INC.
8. If NG, go to "DIAGNOSIS PROCEDURE ".