LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> ID Registration Without Transmitter Activation Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ID Registration Without Transmitter Activation Tool

  1. With the ignition switch in OFF position, connect CONSULT scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6. Adjust the tire pressure to the values specified in the appropriate Sensor ID Registration Tire Pressure Specifications  table below, and drive the vehicle at 25 mph (40 km/h) or more for a few minutes.
    Sensor ID Registration Tire Pressure Specifications

    Tire Position Tire Pressure - psi (kPa)
    Front Left 36 (250)
    Front Right 33 (230)
    Rear Right 30 (210)
    Rear Left 27 (190)
  7. After completing all ID registrations, press "END" to complete the procedure.
  8. Inflate all tires to specification.
scientia non olet · About LEMON Manuals