TPMS Reminder Reset - Procedure 02: Notes
NOTE:
The low tire pressure warning light does not automatically turn off when the tire pressure is adjusted. After the tire is inflated to the recommended pressure, the vehicle must be driven at speeds above 25 mph (40 km/h) to activate the TPMS and turn off the low tire pressure warning light.
NOTE:
This procedure must be done after replacing wheels, rotating wheels (on vehicles without individual tire pressure display), replacing tire pressure sensor or BCM. See appropriate method below.
NOTE:
To register a new tire pressure sensor, a CONSULT scan tool can be used. A Nissan Signal Tech II scan tool or the Transmitter Activation Tool (J-45295) are used in wake-up procedure and can aid in registration procedure if using the CONSULT tool system. Sensor registration and wake-up methods in this procedure reference CONSULT type scan tool procedures.
NOTE:
If a CONSULT-II is used without also using the CONSULT-II CONVERTER, a malfunction might be detected during self-diagnosis, depending on which control unit carries-out CAN communication.
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the all transmitter ID registration functions: See TPMS Reset - Procedure 04 .
NOTE:
Except for Juke and Leaf models, if tire pressure sensor was replaced, the new sensor will be in an "asleep" mode. To wake up sensor, see Transmitter Wake Up Operation .
NOTE:
For sensor registration, see appropriate procedure.