Specifications With Consult
CAUTION:
The output signal indicates the EPS control unit calculation date. The normal values will be displayed even in the event that the output circuit (harness) is open.
| Monitor item (Unit) |
Content |
Condition |
Display value |
| BATTERY VOLT (V) |
Power supply voltage for EPS control unit |
Ignition switch: ON |
Battery voltage |
| TORQUE SENSOR (Nm) |
Steering wheel turning force |
Engine running |
Steering wheel: Not
steering (There is no steering force) |
0.00 Nm |
| Steering wheel: Steering |
0 - 8.19 Nm (The value is changed according to steering left or right) |
| MOTOR SIG (A) |
Command current to EPS motor |
Engine running |
Steering wheel: Not
steering (There is no steering force) |
0.00 A |
| Steering wheel: Steering |
0 - 84 A (The value is changed according to steering left or right) |
| C/U TEMP (°) |
EPS control unit temperature |
Ignition switch: ON |
Temperature in control unit |
| ASSIST LEVEL (%) |
Assist available level |
Engine running |
Steering wheel: Normal steering |
100% |
| Steering wheel: Excessive steering |
Gradually-decreased from 100% |
| VEHICLE SPEED (km/h) or (mph) |
Vehicle speed |
Vehicle stopped |
0 km/h (0 mph) |
| While driving |
Approximately equal to the indication on speedometer (Inside of ±10%) |
| WARNING LAMP (ON/OFF) |
EPS warning lamp condition |
EPS warning lamp: ON |
ON |
| EPS warning lamp: OFF |
OFF |
| ENGINE STATUS (RUN/CRANK/STALL/STOP) |
Engine status |
Engine stopped |
STOP |
| Engine stalled |
STALL |
| Engine cranking |
CRANK |
| Engine running |
RUN |