Removal and Installation: Installation

CAUTION:

Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
After installing key interlock cable to CVT shift selector assembly, make sure that casing cap and bracket are firmly secured in their positions.

Place the shift selector in the "P" position.
Turn ignition switch to "ACC" or "ON" position.
Set the key interlock cable (1) to the key cylinder (2).
Install the lock plate (A) to the holder (B).
Turn ignition switch to "LOCK" position.

Fig 1: Identifying Key Interlock Cable, Key Cylinder, Lock Plate And Holder
Courtesy of NISSAN NORTH AMERICA, INC.
Temporarily install the adjust holder (A) to the key interlock rod (B).
Install the casing cap (C) to the cable bracket (D) on the CVT shift selector assembly.
CAUTION:
- Do not bend or twist key interlock cable excessively when installing.
- After installing key interlock cable to cable bracket (D) on CVT shift selector assembly, make sure casing cap (C) is firmly secured in cable bracket (D) on CVT shift selector assembly.
- If casing cap (C) is loose [less than 39.2 N (4.0 kg, 8.8 lb) removing force], replace key interlock cable.
Fig 2: Installing Casing Cap On CVT Shift Selector Cable Bracket
Courtesy of NISSAN NORTH AMERICA, INC.
Place the shift selector in the "P" position.
Pull the adjust holder (C) all the way to the left on the key interlock rod (B). Move the slider (A) toward the key interlock rod (B) and lock it.
CAUTION:
- Do not press tabs when holding slider (A).
- Do not apply any force to key interlock rod (B) when sliding slider (A).
Fig 3: Identifying Adjust Holder And Key Interlock Rod
Courtesy of NISSAN NORTH AMERICA, INC.
Secure the key interlock cable with the clip.
Installation of the remaining components is in the reverse order of removal.
Check shift lock system. Refer to "DESCRIPTION ".