LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2012 >> Sentra SE-R >> Repair and Diagnosis >> Transmission >> Automatic Transmission (CVT) >> Service Information >> Precautions >> Service After Replacing TCM, Transaxle Assembly, or Control Valve >> Pattern B
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pattern B

  1. Turn ignition switch ON after replacing each part.
  2. Connect the vehicle with CONSULT.
  3. Start engine.
    CAUTION: Never start driving.
  4. Select "Data monitor" in "TRANSMISSION".
  5. Warm up transaxle assembly until "ATFTEMP COUNT" indicates 47 [approximately 20°C (68°F)] or more, and then turn ignition switch OFF.
  6. Turn ignition switch ON.
    CAUTION: Never start engine.
  7. Select "Self Diagnostic Results" in "TRANSMISSION".
  8. Shift the shift lever to "R" position.
  9. Depress slightly the accelerator pedal (Pedal angle: 2/8) while depressing the brake pedal.
  10. Attempt to select "Erase" with step 9.
  11. Release brake pedal and accelerator pedal.
  12. Turn ignition switch OFF while keeping the shift lever in "R" position.
  13. Wait approximately 10 seconds.
  14. Turn ignition switch ON while keeping the shift lever in "R" position.
  15. Select "Special function" in "TRANSMISSION".
  16. Check that the value on "CALIB DATA" in CONSULT is the same as the data listed in the table below.
    • Restart the procedure from step 3 if the values are not the same.
    CALIB DATA

    Item name Display value
    UNIT CLB ID 1 00
    UNIT CLB ID 2 00
    UNIT CLB ID 3 00
    UNIT CLB ID 4 00
    UNIT CLB ID 5 00
    UNIT CLB ID 6 00
  17. Shift the shift lever to "P" position.
  18. Check that the shift position indicator in combination meter turns ON. (It indicates approximately 1 or 2 seconds after shifting the shift lever to "P" position.)
scientia non olet · About LEMON Manuals