Component Function Check

With CONSULT

1. Turn ignition switch ON.
2. Select "BRAKE SW1" in "DATA MONITOR" mode of "ENGINE" using CONSULT.
3. Check "BRAKE SW1" indication as per the following conditions.

   Monitor item	Condition		Indication
   BRAKE SW1	Brake pedal	Slightly depressed	OFF
   		Fully released	ON

Without CONSULT

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals as per the following.

   ECM			Condition		Voltage (Approx.)
   Connector	+	-
   	Terminal
   E16	100	108	Brake pedal	Slightly depressed	0 V
   				Fully released	Battery voltage

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Proceed to "DIAGNOSIS PROCEDURE ".