Component Function Check

Turn ignition switch OFF, and restart engine.

Does the engine start? 

YES-1: With CONSULT: GO TO 2.

YES-2: Without CONSULT: GO TO  3.

NO: Go to "DIAGNOSIS PROCEDURE ".

With CONSULT 

1. Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
2. Make sure that each circuit produces a momentary engine speed drop.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".

Without CONSULT 

1. Let engine idle.
2. Check the voltage signal between ECM harness connector and ground with an oscilloscope.

   ECM				Voltage signal
   +		-
   Connector	Terminal	Connector	Terminal
   F7	17	E16	108	Courtesy of NISSAN NORTH AMERICA, INC.
   	18
   	21
   	22

   NOTE: The pulse cycle changes depending on RPM at idle.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Go to "DIAGNOSIS PROCEDURE ".