LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2013 >> Leaf SL >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Control System (Power Distribution System) >> System Description >> System >> Fail-safe >> Fail-Safe Control By DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fail-Safe Control By DTC

BCM performs fail-safe control when any DTC are detected.

Display contents of CONSULT Fail-safe Cancellation
B2192: ID DISCORD BCM-ECM(1) Inhibit setting the vehicle to READY Erase DTC
B2193: CHAIN OF BCM-ECM(1) Inhibit setting the vehicle to READY Erase DTC
B2195: ANTI-SCANNING Inhibit setting the vehicle to READY Power switch ON → OFF
B2196: DONGLE NG Inhibit setting the vehicle to READY Erase DTC
B2198: IMMOBI ANT NG Inhibit setting the vehicle to READY Erase DTC
B261E: FUEL MIS CONFIG Inhibit setting the vehicle to READY When the VCM status signal is normally received from VCM.
B26F1: IGN RELAY OFF STUCK Inhibit setting the vehicle to READY When the following conditions are fulfilled
  • Power switch ON signal (CAN: Transmitted from BCM): ON
  • Power switch ON signal (CAN: Transmitted from IPDM E/R): ON
B26F2: IGN RELAY ON STUCK Inhibit setting the vehicle to READY When the following conditions are fulfilled
  • Power switch ON signal (CAN: Transmitted from BCM): OFF
  • Power switch ON signal (CAN: Transmitted from IPDM E/R): OFF
B26F7: LF DRIVER COMMUNICATION Inhibit setting the vehicle to READY When inside key antennas function normally
U0415: VDC CAN CIRC2 Inhibit setting the vehicle to READY When vehicle speed signal (Meter) (CAN) is received normally
(1) "ECM" is indicated on CONSULT display, however this means VCM on this vehicle.
scientia non olet · About LEMON Manuals