LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2013 >> Quest S >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> System Description >> System >> VDC Function >> VDC FUNCTION: System Description >> Input Signal And Output Signal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Input Signal And Output Signal

Major signal transmission between each unit via communication lines is shown in the following table.

Component Signal description
Yaw rate/side G sensor Mainly transmits the following signals to ABS actuator and electric unit (control unit) via communication line(1).
  • Yaw rate signal
  • Side G sensor signal
ECM Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.
  • Acceleration pedal position signal
  • Engine speed signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication.
  • Target throttle position signal
TCM Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.
  • Shift position signal
  • Current gear position signal
  • P range signal
  • R range signal
  • N range signal
Steering angle sensor Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.
  • Steering angle sensor signal
Combination meter Mainly transmits the following signals to ABS actuator and electric unit (control unit) via CAN communication.
  • Brake fluid level switch signal

Mainly receives the following signals from ABS actuator and electric unit (control unit) via CAN communication.
  • VDC warning lamp signal
  • VDC OFF indicator lamp signal
(1) Communication line between yaw rate/side G sensor and ABS actuator and electric unit (control unit)
scientia non olet · About LEMON Manuals