LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2013 >> Sentra FE+SV >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Security Control System (With Intelligent Key System)) >> Basic Inspection >> Additional Service When Replacing Control Unit >> BCM >> Work Procedure >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

WARNING: This page is about a different car, the 2017 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

  1. SAVING VEHICLE SPECIFICATION

    G-20 CONSULT

    Enter "Re/Programming, Configuration" and perform "Before Replace ECU" to save or print current vehicle specification.

    NOTE:

    If "Before Replace ECU" cannot be used, use the "After Replace ECU" or "Manual Configuration" after replacing BCM.

    GO TO STEP 2  .

  2. REPLACE BCM

    Replace BCM. Refer to REMOVAL AND INSTALLATION .

    GO TO STEP 3  .

  3. WRITING VEHICLE SPECIFICATION

    G-20 CONSULT

    1. Enter "Re/Programming, Configuration".
    2. If "Before Replace ECU" operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press "Confirm" to write vehicle specification. Refer to WORK PROCEDURE .
    3. If "Before Replace ECU" operation was not performed, select "After Replace ECU" or "Manual Configuration" to write vehicle specification. Refer to WORK PROCEDURE .

    GO TO STEP 4  .

  4. REGISTER INTELLIGENT KEYS

    For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.

    Work End.

scientia non olet · About LEMON Manuals