Operation When Intelligent Key Is Carried

When the push-button ignition switch is pressed, the BCM activates the inside key antenna and transmits the request signal to the Intelligent Key.
The Intelligent Key receives the request signal and transmits the Intelligent Key ID signal to the BCM.
BCM receives the Intelligent Key ID signal via remote keyless entry receiver and verifies it with the registered ID.
BCM turns ACC relay ON and transmits the ignition power supply ON signal to IPDM E/R.
IPDM E/R turns the ignition relay ON and starts the ignition power supply.
IPDM E/R turns the starter control relay ON for engine starting in advance.
BCM detects the selector lever position and brake pedal operation condition.
BCM transmits the starter request signal to IPDM E/R and turns the starter relay in IPDM E/R ON if BCM judges that the engine start condition* is satisfied.
Power supply is supplied through the starter relay and the starter control relay to operate the starter motor.
CAUTION: If a malfunction is detected in the Intelligent Key system, the "KEY" warning lamp on the combination meter illuminates. At that time, the engine cannot be started.
When BCM receives feedback signal from ECM indicating that the engine is started, the BCM transmits a stop signal to IPDM E/R and stops cranking by turning OFF the starter motor relay. (If engine start is unsuccessful, cranking stops automatically within 5 seconds.)
CAUTION: When the Intelligent Key is carried outside of the vehicle (inside key antenna detection area) while the power supply is in the ACC or ON position, even if the engine start condition* is satisfied, the engine cannot be started.

*: For the engine start condition, refer to "IGNITION SWITCH POSITION CHANGE TABLE BY PUSH-BUTTON IGNITION SWITCH OPERATION ".