Component Function Check

1. Turn ignition switch OFF.
2. Start engine.

   Does the engine start? 

   YES: GO TO 2.

   NO: Proceed to "DIAGNOSIS PROCEDURE ".

With CONSULT

1. Perform "POWER BALANCE" in "ACTIVE TEST" mode of "ENGINE" using CONSULT.
2. Check that each circuit produces a momentary engine speed drop.

Without CONSULT

1. Let engine idle.
2. Check the voltage signal between ECM harness connector and ground with an oscilloscope.

   ECM				Voltage signal
   +		-
   Connector	Terminal	Connector	Terminal
   F25	86	E16	128
   	87
   	90
   	91

   NOTE: The pulse cycle changes depending on rpm at idle.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Proceed to "DIAGNOSIS PROCEDURE ".