| BATTERY VOLT (V) |
Displays the power supply voltage for power steering control module. |
| STEERING ANGLE (deg) |
Displays the steering angle based on the steering angle signal transmitted by CAN communications. |
| STR ANG SPD (deg/s) |
Displays the steering angle speed based on the steering angle signal transmitted by CAN communications. |
| MOTOR CURRENT (A) |
Displays the current value consumed by power steering control module. |
| MTR REV SPD COMM (RPM) |
Displays the power steering motor speed command value. |
| MTR REV SPD (RPM) |
Displays the power steering motor speed. |
| C/U TEMP (°C or °F) |
Displays the temperature of the power steering control module. |
| C/U TEMP A (°C or °F) |
Displays the temperature of the power steering control module. |
| MTR ASSIST (%) |
Displays the current percentage of the allowable assist ratio power steering motor. |
| ESTM VHCL SPD (km/h or mph) |
Displays the vehicle speed calculated by the power steering control module. |
| WARNING LAMP (On/Off) |
Hydraulic pump electric power steering system warning lamp control status is displayed. |
| ENGINE STATUS (STOP/RUN/CRANK) |
Engine speed is displayed from engine condition signal with CAN communication |
| VHCL SPD JUDGE (OK/NG) |
Displays the receiving status of the vehicle speed signal transmitted by CAN communications. |