Power Supply Position Change Table By Push-Button Ignition Switch Operation
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
VEHICLE SPEED SPECIFICATION
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| With CVT | With M/T | |||
| Selector lever position | Brake pedal condition | Clutch pedal condition | ||
| OFF → ACC | - | Released | Released | 1 |
| OFF → ACC → ON | - | Released | Released | 2 |
| OFF → ACC → ON → OFF | - | Released | Released | 3 |
| OFF → START ACC → START ON → START |
P (Park) or N (Neutral) | Depressed | Depressed | 1 |
| Engine is running → OFF | - | - | - | 1 |
VEHICLE SPEED SPECIFICATION
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| With CVT | With M/T | |||
| Selector lever position | Brake pedal condition | Clutch pedal condition | ||
| Engine is running → ACC | - | - | - | Emergency stop operation |
| Engine stall return operation while driving | N (Neutral) | Released | Depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.