Data Monitor Mode
NOTE:
The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
| Monitor item (Unit) | Remarks |
|---|---|
| BATTERY VOLT (V) | Displays the power supply voltage for power steering control module. |
| STR ANG SPD (deg/s) | Displays the steering angle speed based on the steering angle signal transmitted by CAN communications. |
| MOTOR CURRENT (A) | Displays the current value consumed by power steering control module. |
| MTR REV SPD COMM (rpm) | Displays the power steering motor speed command value. |
| MTR REV SPD (RPM) | Displays the power steering motor speed. |
| C/U TEMP (°C or °F) | Displays the temperature of the power steering control module. |
| C/U TEMP A (°C or °F) | Displays the temperature of the power steering control module. |
| MTR ASSIST (%) | Displays the current percentage of the allowable assist ratio power steering motor. |
| ESTM VHCL SPD (km/h or mph) | Displays the vehicle speed calculated by the power steering control module. |
| WARNING LAMP (On/Off) | Hydraulic pump electric power steering system warning lamp control status is displayed. |
| ENGINE STATUS (STOP/RUN/CRANK) | Engine speed is displayed from engine condition signal with CAN communication |
| VHCL SPD JUDGE (OK/NG) | Displays the receiving status of the vehicle speed signal transmitted by CAN communications. |