Diagnosis Procedure
- CHECK START
Check front and rear brake force distribution using a brake tester.
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Check brake system.
- CHECK FRONT AND REAR AXLE
Make sure that there is no excessive play in the front and rear axles. Refer to front: INSPECTION , rear: INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace malfunctioning components.
- CHECK WHEEL SENSOR AND SENSOR ROTOR
Check the following:
- Wheel sensor installation for damage
- Sensor rotor installation for damage
- Wheel sensor connector
- Wheel sensor harness
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
- Replace wheel sensor REMOVAL AND INSTALLATION (front) or REMOVAL AND INSTALLATION (rear).
- Replace sensor rotor REMOVAL AND INSTALLATION (front) or REMOVAL AND INSTALLATION (rear).
- Repair harness.
- CHECK ABS WARNING LAMP DISPLAY
Make sure that the ABS warning lamp is turned off after the ignition switch is turned ON or when driving.
Is the inspection result normal?
YES
Inspection End.
NO
Perform "Self Diagnostic Result". Refer to CONSULT FUNCTION (ABS) .