Test Item

TEST ITEM	CONDITION	JUDGMENT	CHECK ITEM (REMEDY)
FUEL INJECTION	Engine: Return to the original non-standard condition Change the amount of fuel injection using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Fuel injector Air fuel ratio (A/F) sensor 1
ENG COOLANT TEMP	Engine: Return to the original non-standard condition Change the engine coolant temperature using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Engine coolant temperature sensor Fuel injector
PURG VOL CONT/V	Engine: After warming up, run engine at 1, 500 rpm. Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.	Engine speed changes according to the opening percent.	Harness and connectors Solenoid valve
FUEL/T TEMP SEN	Change the fuel tank temperature using CONSULT.
INT V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change intake valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Intake valve timing control solenoid valve
EXH V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change exhaust valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Exhaust valve timing control solenoid valve
COOLING FAN*	Ignition switch: ON Turn the cooling fan "HI", "MID", "LOW" and "OFF" using CONSULT.	Cooling fan moves and stops.	Harness and connectors Cooling fan motor IPDM E/R
VIAS S/V-1	Ignition switch: ON Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.	Solenoid valve makes the operating sound.	Harness and connectors Solenoid valve
ENGINE MOUNTING	Ignition switch: ON Turn electronic controlled engine mount "IDLE" and "TRVL" with CONSULT.	Electronic controlled engine mount makes the operating sound.	Harness and connectors Electronic controlled engine mount
VIAS S/V-2	Ignition switch: ON Turn solenoid valve "ON" and "OFF" using CONSULT and listen to operating sound.	Solenoid valve makes the operating sound.	Harness and connectors Solenoid valve
IGNITION TIMING	Engine: Return to the original non-standard condition Timing light: Set Retard the ignition timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Perform Idle Air Volume Learning.
POWER BALANCE	Engine: After warming up, idle the engine. A/C switch OFF Selector lever: P or N position Cut off each injector signal one at a time using CONSULT.	Engine runs rough or stops.	Harness and connectors Compression Fuel injector Power transistor Spark plug Ignition coil
VENT CONTROL/V	Ignition switch: ON (Engine stopped) Turn solenoid valve "ON" and "OFF" with the CONSULT and listen to operating sound.	Solenoid valve makes an operating sound.	Harness and connectors Solenoid valve

* : Leaving cooling fan OFF with CONSULT while engine is running may cause the engine to overheat.