Ignition Switch Position Change Table By Push-Button Ignition Switch Operation
The ignition switch position can be changed by the following operations:
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna or when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below:
- When starting the engine, the BCM monitors under the engine start conditions:
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
VEHICLE SPEED: LESS THAN 4 KM/H (2.5 MPH)
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| OFF → ACC | - | Not depressed | 1 |
| OFF → ACC → ON | - | Not depressed | 2 |
| OFF → ACC → ON → OFF | - | Not depressed | 3 |
| OFF → START ACC → START ON → START |
P or N position | Depressed | 1 |
| Engine is running → OFF | - | - | 1 |
VEHICLE SPEED: 4 KM/H (2.5 MPH) OR MORE
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → ACC | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.