Test Item

TEST ITEM	CONDITION	JUDGMENT	CHECK ITEM (REMEDY)
FUEL INJECTION	Engine: Return to the original trouble condition Change the amount of fuel injection using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Fuel injector Air fuel ratio (A/F) sensor 1
ENG COOLANT TEMP	Engine: Return to the original trouble condition Change the engine coolant temperature using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Harness and connectors Engine coolant temperature sensor Fuel injector
PURG VOL CONT/V	Engine: After warming up, run engine at 1, 500 RPM. Change the EVAP canister purge volume control solenoid valve opening percent using CONSULT.	Engine speed changes according to the opening percent.	Harness and connectors Solenoid valve
FUEL/T TEMP SEN	Change the fuel tank temperature using CONSULT.
COOLING FAN*	Ignition switch: ON Turn the cooling fan "LOW", "HI" and "OFF" CONSULT.	Cooling fan moves and stops.	Harness and connectors IPDM E/R (Cooling fan relay) Cooling fan motor
ALTERNATOR DUTY	Engine: Idle Change duty ratio using CONSULT.	Battery voltage changes.	Harness and connectors IPDM E/R Alternator
FUEL PUMP RELAY	Ignition switch: ON Turn the fuel pump relay "ON" and "OFF" using CONSULT and listen to operating sound.	Fuel pump relay makes the operating sound.	Harness and connectors Fuel pump relay
IGNITION TIMING	Engine: Return to the original trouble condition Timing light: Set Retard the ignition timing using CONSULT.	If trouble symptom disappears, see CHECK ITEM.	Perform Idle Air Volume Learning.
POWER BALANCE	Engine: After warming up, idle the engine. A/C switch OFF Shift lever: P or N (CVT), Neutral (M/T) Cut off each fuel injector signal one at a time using CONSULT.	Engine runs rough or dies.	Harness and connectors Compression Fuel injector Power transistor Spark plug Ignition coil
VENT CONTROL/V	Ignition switch: ON Turn solenoid valve ON and OFF with the CONSULT and listen to operating sound.	Solenoid valve makes an operating sound.	Harness and connectors EVAP canister vent control solenoid valve
INT V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change intake valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Intake valve timing control solenoid valve
EXH V/T ASSIGN ANGLE	Engine: Return to the original non-standard condition Change exhaust valve timing using CONSULT.	If malfunctioning symptom disappears, see CHECK ITEM.	Harness and connectors Exhaust valve timing control solenoid valve
ACTIVE GRILLE SHUTTER	NOTE: Initial position learning is required every time when the ignition switch is turned OFF. Engine: Idle speed Touch "CALIBRTN" to perform initial position learning. Touch "OPEN" or "CLOSE" to operate active grille shutter.	Active grille shutter fully opens or fully closes.	Harness or connector Active grille shutter actuator Active grille shutter

* : Leaving cooling fan OFF with CONSULT while engine is running may cause the engine to overheat.